Laboratory
The quality control laboratory of Kaveh Copper Industries Company is equipped with precise laboratory equipment to produce quality copper wire, and the activities of this unit range from the stage of raw materials entering the company to the product leaving the company.
Quantummetry
Copper-based quantum apparatus with an accuracy of 0.1 ppm and a wide range of impurity concentration measurements are used to analyze and produce wires with the lowest impurities. An analysis is performed at all stages of preparation to investigate and measure contaminants in the melt.
Oxygen measurement
To measure the concentration of oxygen in the melt and control the amount of oxygen and measure the oxygen of the product, oxygen analysis devices with an accuracy of 0.1 ppm are used. These devices are capable of measuring oxygen in the range 0.1ppm up to 5%.
Tensile
Tensile testing device is used to measure the elongation. In addition to the elongation, this device can measure tensile strength, yield strength, etc.
Twisting
The measurement of the number of turns to failure and the internal and surface defects of the wire is done using a bending machine.
Electrical resistance
Measure the electrical resistance of the rod using a resistor meter with an accuracy of 1 micro-ohm and then calculate the electrical conductivity based on IACS%.
Measurement of the surface oxide layer
According to Faraday law, the thickness of the surface oxide layer of copper wire (Cu2O and CuO) is measured to the nearest 1 angstrom.
Selling copper wire
8mm copper wire produced at Kaveh Copper Company, using modern global methods and with the highest quality, is offered as an ideal raw material for copper wire and cable manufacturers. Contact us to place an order and get more information.
Copper wire Kaveh Copper Industries
FRHC Rod
This type of 8 mm copper wire produced by Kaveh Copper Industries is recycled from copper waste and produced after going through charging, refining, and casting processes.
Wire
The 8 mm copper wire produced by Kaveh Copper Industries, which is produced from cathode raw material or scrap, is delivered to Bafe Raad Kaveh Company, if needed, to be converted into drawn and stranded wires in various sizes.
ETP Rod
This type of copper wire produced by Kaveh Copper Industries is produced from cathode raw material. Cathodes are converted into 8 mm copper wire in shaft furnaces and through casting processes.